#1 Logitech and Windows 7
Posted: Thu Dec 10, 2009 8:04 am
Not sure if anyone else has a setup to examine this issue or not, but here it goes.
Got my new rig put together and installed windows 7 64bit on it. Runs fine and smooth. Went to hook up my Logitech diNovo mini through bluetooth. Syncs up fine, good response, no lag, everythings going good.
Then I install logitech's setpoint software (V4.80) for Win7 x64 so I can configure some of the buttons and such for my specialty software.
Every time I reboot the computer or log off it loses my mouse and keyboard tabs under setpoint. Logitech's only answer they'll give is to uninstall and reinstall set point. Did that about a dozen times last night and it would work fine but then I'd reboot and it would lose the data again.
has anyone else ran into this issue or a similar one that can offer some ideas?
Got my new rig put together and installed windows 7 64bit on it. Runs fine and smooth. Went to hook up my Logitech diNovo mini through bluetooth. Syncs up fine, good response, no lag, everythings going good.
Then I install logitech's setpoint software (V4.80) for Win7 x64 so I can configure some of the buttons and such for my specialty software.
Every time I reboot the computer or log off it loses my mouse and keyboard tabs under setpoint. Logitech's only answer they'll give is to uninstall and reinstall set point. Did that about a dozen times last night and it would work fine but then I'd reboot and it would lose the data again.
has anyone else ran into this issue or a similar one that can offer some ideas?